What is the correct order for these filters? Because it works, but I get green tints sometimes, and when I remove Decross, it works.
Decross > Deinterlace > Crop > QTGMCFilter > BasicVSR++ > CCD > Resize
Order should be alright.
You might be able to fix color bleeding caused by DeCross by adjusting the settings.
Hi, thanks again for your help!
The QTGMC Input 3 method works well overall. However, on some scenes it sometimes creates black line artifacts (I’ve attached a screenshot for reference).
Also, regarding the "Decross" settings, what values would be the most optimal for my video?
Thanks in advance!
[
attachment=3563]
About DeCross: No clue, you will have to try.
For QTGMC:
That doesn't really look like something I would associate with QTGMC, but
a. try Input mode 2
b. try whether using another 'source matching' value helps
Cu Selur
As a side note: Have you tried using LUTDeRainbow instead of DeCross?
Yes, I did use another filter, but I’m not sure if the settings are correct.
I’ve attached a sample of the source video so you can take a look and see if there’s a way to fix the issue.
Thanks again for your help!
http://titant.free.fr/tmp/A1_t04.mkv
When I use QTGMC, this is the issue I run into. However, you can see that it does remove the flickering on the boat’s ropes.
[
attachment=3564]
ReduceFlicker(clip, strength=3, aggressive=1) seems to work fine with the flickering.
This
script seemed to
work fine for me.
Filters I used are:
- TIVTC for the combing
- ReduceFlicker for the flickering
- Crop for the black bars
- Checkmate for some of the dot crawlers (especially on the right side of the frame)
- RainbowSmooth for the rainbows
- (edge masked) BasicVSR++ to fix the general edges
- LumaSharpen to emphasize the edges
- YAHR to lessen the white halos
- Resized to 1:1 PAR
- Santiang to remove staircasing artifacts on edges.
There are still rainbows in a few frames, but nothing that annoys me.
Cu Selur
Thank you so much! 😊 Thanks to you and your advice, I’ll finally be able to encode my episode in good quality! 🙏
Can you Show me your Setup now for that, lastchance22?
@ powerthrash4K
vpoursynth ovrewrite telecine
misc UI show masked controls
other basicvsr FP16
edgemask (bloated) expand/shrink 1
denoise CCD
threshold 10
derainbow
decross 60/60
RainbowSmooth
decrawl
DotKill Spacial Iteration: 2
Sharpen
Luma Sharpen
Line
Santiag
Frame/stabilize
SmallDeflicker -> Light Repair