+- Selur's Little Message Board (https://forum.selur.net)
+-- Forum: Hybrid - Support (https://forum.selur.net/forum-1.html)
+--- Forum: Problems & Questions (https://forum.selur.net/forum-3.html)
+--- Thread: Crash DVD encoding and Vapoursynth (/thread-3438.html)
RE: Crash DVD encoding and Vapoursynth - Devilman1 - 16.10.2023
I tried to extract the subtitle from a m2ts file but I receive an error message even if tsmuxer can do it without any problem, in fact I did it manually.
I don't know if it's a bug.
RE: Crash DVD encoding and Vapoursynth - Devilman1 - 17.10.2023
I wanted to encode a second Blu-ray but when I click to create the job an error message pop up about invalid GUI state.
RE: Crash DVD encoding and Vapoursynth - Selur - 17.10.2023
Those are rare, haven't seen one for ages.
From the looks of it, this happens when Hybrid tries to extract subtitle from "N:\BDMV\STREAM\00004.m2ts" and decides it can't.
Not sure why it's not using tsMuxeR or ffmpeg => will look at it after work and report back.
Looks a bit like you are using the Subtitle->Tab to load an .mpls file and then try to extract the subtitles through there, instead of using the controls on the Base-tab.
Cu Selur