Crash using custom profile as default - Printable Version +- Selur's Little Message Board (https://forum.selur.net) +-- Forum: Hybrid - Support (https://forum.selur.net/forum-1.html) +--- Forum: Problems & Questions (https://forum.selur.net/forum-3.html) +--- Thread: Crash using custom profile as default (/thread-1620.html)

Crash using custom profile as default - Werve - 01.12.2020 Hello, I noticed a problem that makes it impossible to open (crash). These are the actual steps: 1. I create a profile and save it in Config-Profiles-Global profile 2. I reload it by clicking the "Apply global profile" arrow 3. Enable "Auto save defaults" OR (there is also a problem for) click the "Save selected" arrow for the ALL option in the bottom section "Defaults". 4. The next time you open the program crashes and Windows sends a report to Microsoft (normal behavior) and asks you to close it or debug it. If I remove the profile files saved in AppData-Roaming the program can work again. Attached is the dump after the crash and the profiles created after the "Auto save defaults" option. RE: Crash using custom profile as default - Selur - 01.12.2020 No clue what to do with the dump,... Also this does not happen for me. I tried this: Start Hybrid Reset the setting ('Config->Defaults->Reset->All' + 'Reset selected') Start Hybrid Create a global profile ('Config->Profiles->Global profile' 'Save global profile') Apply the just saved global profile ('Config->Profiles->Global profile->Apply global profile') Enable 'Config->Profiles->Auto save defaults' Close Hybrid Start Hybrid then I deleted everything in my settings folder and put your files in it and tried to start Hybrid an it crashed. So, no clue how to make it happen, but I can reproduce the issue with your saved settings. So starting up a debug build of Hybrid in a debug environment showed that Hybrid tried to access some icon images before they were loaded. -> I'll send you a link to dev version which should fix the issue in ~1/2 hour. Cu Selur