+- Selur's Little Message Board (https://forum.selur.net)
+-- Forum: Hybrid - Support (https://forum.selur.net/forum-1.html)
+--- Forum: Problems & Questions (https://forum.selur.net/forum-3.html)
+--- Thread: Artifacts after Upscale (/thread-3982.html)
Artifacts after Upscale - VUSschneider - 25.01.2025
Hello,
after deinterlacing and upscaling a prores clip i see this artifacts in my output.
Is it a problems caused by my settings or a driver/software issue?
I use vaporynth to deinterlace and vaporsynth frame NNDEI3 resize.
RE: Artifacts after Upscale - Selur - 25.01.2025
I have no problem with QTGMC and NNEDI3 here, so my guess it's a problem with your setup.
Read the sticky on what info is needed to reproduce a bug,...
Quote: Is it a problems caused by my settings or a driver/software issue?Doesn't look like a driver issue or a setting problem (Hybrid settings).
In case your system (cpu, ram, gpu) is over- or underclocked, that is likely the issue.
Not knowing what settings you used etc. I have no way to even try to (properly) reproduce the problem.
What OS and CPU are you using?
Are the artifacts also visible in the Vapoursynth Preview?
Does this happen just with a specific source, or with any source where you apply QTGMC and NNEDI3.
Can you reproduce the problem? Are the artifacts always in the same places?
Cu Selur
RE: Artifacts after Upscale - VUSschneider - 25.01.2025
thank you for fast answer.
i have to check all this.
Setup is windows, AMD Athlon and Nvidia Geforce 3800 RTX
i`ll try another system.
RE: Artifacts after Upscale - Selur - 25.01.2025
Like I wrote, the most likely cause is overclocking of the system. (or hardware issues that might be causes by heat problems, defect hardware, some other tools interfering,..)