This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Selur's Little Message Board › Hybrid - Support › Problems & Questions v
Encode says 130% complete for some reason and hasn't finished

Linear Mode
Encode says 130% complete for some reason and hasn't finished
Selur Offline
the author
*******
Posts: 10.565
Threads: 57
Joined: May 2017
#26
29.09.2024, 19:40
Uploaded a new dev version which should adjust the frame count during analysis, not sure if this does not cause problems on other files from MakeMKV, so best check whether output frame count and frame count shown by Vapoursynth Preview are roughly the same (+/- a few frames).

Cu Selur
----
Dev versions are in the 'experimental'-folder of my GoogleDrive, which is linked on the download page.
Find
Reply


Messages In This Thread
RE: Encode says 130% complete for some reason and hasn't finished - by Selur - 29.09.2024, 19:40

Forum Jump:


Users browsing this thread: 7 Guest(s)