Scunet Strength

[Selur]

Okay, but then it wouldn't be possible to double the frames naturally using QTGMC, right?

There's nothing natural about it. Deinterlacing progressive content will just produce duplicate frames. (This too can be done by using 'Filtering->Speed Change->Scale output frame rate to'.) Problem with this method is that it might introduce additional artifacts due to unnecessary/harmful filtering steps.

As for what I used to cut the video, it was LosslessCut.

note that, unless you only cut on key frames, in general LosslessCut is not lossless.

I’d have to use something like Flowframes instead?

If you want something better than simple duplication of frames: yes, frame interpolation would be what one would choose.

Excellent, is there a way to import this script or just enable CAS at 0.700 and then ScuNet

You should adjust the filter order. The order in which you enable filters, does not influence the filter order.

what's the difference between the regular ScuNet and ScuNet MLRT?

one uses https://github.com/HolyWu/vs-scunet, the other https://github.com/AmusementClub/vs-mlrt to use SCUnet models. Usually one or the other is faster depending on your setup, but they both use the same models (in different formats) and should produce nearly the same output.
(same for DPIR and some other filters)

Cu Selur