using cuvid in hwaccell ffmpeg

[HW decoder]

.. I already send you a link to the dev version via PM before you posted this, you just didn't check your PMs,...

Hi!

I tested the new version.

During the installation an nvenc file is missing, which is not problem if you did not uninstall the previous version.

The Cuvid decoder is faster than the DXVA2 in Hybrid (80 fps vs. 40-50 fps in 1080p@24 Blu-ray and 1080p@24 HEVC materials) but it was not so fast like the "NVENC Cuda" and "NVENC native" decoders (over 500 FPS ) in StaxRip.  Staxrip had a GPU usage around 98%-100%  for the NVENC (AVC and HEVC encoding) + GPU decoding while Hybrid used the "VPE engine" only between 15%-25% for NVENC HEVC and AVC decoding and encoding. I monitored it in the "sensor panel of the  "GPU-Z" GPU information software, where you can see the usage of all important components of your VGA card. So Hybrid did not really use the card efficiently, while StaxRip used it to the max (99)

After the PC tests, I will make my "Laptop tests" too.

I think you can implement these faster decoders too in the Hybrid, because they work well with Avisynth V.synth and FFMPEG too.

Maybe, if you examine StaxRip, you can see and figure out how did they implemented them to their software. Can't you?