sRestore - Hybrid Hybrid_2026.03.21.1

[NoahLoot]

Debug output works fine here, it just does not work with the settings you choose, since it was not designed to work with themtest

No, iam afraid thats not it!

I have reset hybrid to its default settings.  
So that iam not using my personal settings anymore.  

I have toggled "debug" off and back on... , then restarted hybrid.  
i manually have chose different TEMP & Output folders.  So temp and output folder is not the same anymore.

Lastly, i've opened a media file..  
But hybrid didn't created an debug file of me opening a file..  

Usually Hybrid does create a debug from the instant you open a media file.
You don't have to process and complete a job.

Iam strongly convinced it's not due to wrong (same) paths settings selur..

It's an odd issue ...  


I have found out how i can create a debug file every time.  
But it's a strange way of doing it!  Usually in the past hybrid did automatically created debugs on the fly, and every time saved it to the output path.   Even when "output to source path" wos enabled in config>paths.   

Now, it doesn't create the debug in the output folder always..  
Now, it creates and keeps the debug in the previous folder i have MANUALLY (important) have chosen and saved (save all)

So here are the steps to reproduce this phenomenon (hopefully!)

A. start hybrid > go to config and Reset ALL , then hybrid restarts.
B. go to Config > Paths : Choose only Default Output Path 
C. go to Config > internals : Enable / toggle "Create Debug"
D. now click Save ALL (so that hybrid restarst with exactly these settings)

Now, when you load an media file.. a debug will be created in the chosen / default output path..

But here's the odd part...

From here on, When i enable a. "output path to source" + "Temp To Output" so that everything is kept in the same folder.. and press Save ALL as general preset..

Hybrid will keep creating the Debug in the same output folder that initialy is created .. 
So, it's not created in the same output folder from where you load the original media files , you see!?

And this is unusuall behavior from hybrid..  In the past , hybrid always has created and moved the debug to the right output path/folder..  Where or whatever that folder was, hybrid always picked the same output folder as the original source file !

Both sRestore and DeblendS6 should adjust the frame rate according to the frames that get removed.
If you additionally change the frame rate you need to adjust the audio, otherwise the audio should be sync. (assuming it wasn't stretched beforehand, or the source if vfr or something like that)

Cu Selur

by ''additionally change the framerate" do you mean the "filtering > speed change" settings ?
If so yes, if my output fps is 24fps , i make sure the audio speed is adjusted to that new framerate aswell by decimal method ie: 25 > 24..  

The source however is 50fps / progressive.. But when i choose 50  > 24 in audio setting, the video plays in slowmotion .

No, i have to use 25 > 24 + pitch correction for AV sync , and as for DeblendS6 the target FPS has to BE 25.000 fps for perfect playback and AV sync   .

Thrust me i want to do it your way, but the settings iam using seems to be the only settings that perfectly works ..  Even when it doesn't make sense ...


Thanks though,