This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

[BUG] NVEnc / H265 / Tune "UHQ" = incompatible command
#3
Got it, UHQ with HEVC failed because Hybrid’s default of 3 B-frames is too few for it.
--tune uhq turns on NVENC’s temporal filter (tfLevel: 4) for HEVC and AV1, and that filter needs at least 4 B-frames.
Hybrid always writes --bframes, and its default is 3, so NVENC rejects the setup with error 8. Testing NVEncC directly:

Tested it on my system.

NVEncC --tune uhq:(RTX 4080, driver 621.14, NVEncC 9.40)

Codec

--bframes 0-3

--bframes 4

--bframes 3 --tf-level 0
HEVC
error 8
works
works
AV1
error 8
works
works
H.264
works
works
works



=> I'll adjust Hybrid to raise bFrames minimum to 4 under uhq (HEVC/AV1). Will report back once I did the fix and uploaded a new dev.

Cu Selur
----
Dev versions are in the 'experimental'-folder of my GoogleDrive, which is linked on the download page.
Reply


Messages In This Thread
RE: NVEnc / H265 / Tune "UHQ" = incompatible command - by Selur - 12.11.2026, 08:23

Forum Jump:


Users browsing this thread: 1 Guest(s)