19.09.2018, 15:14
hi,
what I do :
1.
- load a H264 file containing X cartoons
- add X chapters with the names of the cartoons, beginning at 00:00 (each chapter is put at the beginning of the cartoon, not the end)
- set audio to passthrough & video to 'NVEnc / h265 / variable bitrate (HQ)'
- enable Base->Generate
- crop if needed
- PAR 1x1
- enable Config->Output->Filename Generation->Output Filename Generation->Use chapter names - set a suffix to the file name
- create & start the job --> result ok with x chapters
2.
- put the encoded file in Hybrid
- set audio/video to passthrough
- enable Config->Output->Filename Generation->Output Filename Generation->Use chapter names (--> it's always checked)
- delete the suffix
- delete the chapter names, because I think that there are not deleted automatically when loading the new file
- enable Base->Generate (it's always checked)
- hit 'Queue Chapters' & start the job queue
--> In that case, I don't have the chapter names
If i keep them, I have them as suffix at the end of the filename.
Other parameters checked (by default) :
- chapter -> import chapters on input change
- chapter -> auto adjust chapter names
(all others are the ones set by default)
Hint : maybe I should delete the chapters BEFORE loading the encoded file & see if it works ?
Regards
what I do :
1.
- load a H264 file containing X cartoons
- add X chapters with the names of the cartoons, beginning at 00:00 (each chapter is put at the beginning of the cartoon, not the end)
- set audio to passthrough & video to 'NVEnc / h265 / variable bitrate (HQ)'
- enable Base->Generate
- crop if needed
- PAR 1x1
- enable Config->Output->Filename Generation->Output Filename Generation->Use chapter names - set a suffix to the file name
- create & start the job --> result ok with x chapters
2.
- put the encoded file in Hybrid
- set audio/video to passthrough
- enable Config->Output->Filename Generation->Output Filename Generation->Use chapter names (--> it's always checked)
- delete the suffix
- delete the chapter names, because I think that there are not deleted automatically when loading the new file
- enable Base->Generate (it's always checked)
- hit 'Queue Chapters' & start the job queue
--> In that case, I don't have the chapter names
If i keep them, I have them as suffix at the end of the filename.
Other parameters checked (by default) :
- chapter -> import chapters on input change
- chapter -> auto adjust chapter names
(all others are the ones set by default)
Hint : maybe I should delete the chapters BEFORE loading the encoded file & see if it works ?
Regards