[INFO] [Feature request] Keep height ?

[weyb06]

Hello,

so assuming I'd like hybrid (on multi-source input) to :
1/set the output PAR =1x1
2/and keep the height of each video,
I understand that Hybrid will modify the width only when the input PAR is not 1x1 : is it the case ?

So from what I understand, I should have the following parameters :

*Crop/Resize > Base > PAR > Output PAR> Convert output to PAR = "square pixel"
    --> this enables automatically Crop/Resize > Base > "Resize"
    --> this sets Crop/Resize > Base > Picture resize > resize method = "10 - bicubic spline"
    --> this enables Crop/Resize > Base > Picture resize > "Auto adjust" --> I chose "width" (I understand the width will adjust to the height with output PAR = 1x1)
    --> then the "target resolution" is set to a certain value in Hybrid --> is it a value specific for the 1st video to be encoded, or for all the videos ?

*Crop/Resize > Misc > Misc > keep resize for new source : disabled
*Crop/Resize > Misc > Misc > adjust keep resize for source : disabled
*Crop/Resize > Misc > On source change > auto crop : enabled

So for each new video on multi-source input, Hybrid will detect the height, keep it, adjust eventually the width and encode.
do you agree ?

regards