x.264 t_mod upgrade

[Garo 7]

I don't see any overview what is different from this version to the normal x264.
So it' hard to tell if anything would break by simply replacing the x264.exe with the x264 t_mod build.
If it's just a fprofiled build, then replacing the binary should be no problem.
If parameters changed, it might cause problems.

Cu Selur

Well I was told that it was required to support these settings: (perhaps some are new? the aq3? aq boundry?)

--crf 15.0000 --no-8x8dct --partitions all --chroma-qp-offset -4 --profile high10 --deblock 0:-1 --ref 16 --no-mbtree --psy-rd

0.82:0.00 --merange 32 --subme 10 --me umh --trellis 2 --no-dct-decimate --bframes 16 --b-adapt 2 --direct auto --subme

10 --no-fast-pskip --keyint 240 --min-keyint 24 --rc-lookahead 60 --partitions all --qcomp 0.75 --ref 16 --aq-mode 3 --aq-

strength 0.85 --aq2-strength 0.88 --aq2-sensitivity 17.00 --aq3-mode 4 --aq3-strength 0.8 --aq3-sensitivity 10.00 --aq3-

boundary 768:256:96 --output-depth 10

Well, I am not certain.  I was hoping to find these settings in the menus in hybrid rather than be forced to use batchfile and script.

Are the aq3 setting already part of the Hybrid Vapoursynth settings? I think these are the only ones that I was uncertain about.

Let me know if you can perhaps guide me on this. Thank you!

Garo