10.04.2020, 12:38
Hi
I followed the guide "30 fps to 60" on the forum. I'm trying to render a 2880x2160 mp4 x264 25fps to 50fps with Avisynth "smooth" settings.
Encoding is set to specific bitrate 2-pass. AVC High 5.2.
But the rendering is stopping at the beginning sometimes at 1% sometimes at 3 or 4%. and i'm not getting any error message in the log.
It just stop and stay at whatever % it's blocked to.
I mannaged to get it done only once after 5 or 6 trials with a short clip of 45 secondes. and then i tried again with the exact same settings for a 30 minutes clip and it always stops.
I followed the guide "30 fps to 60" on the forum. I'm trying to render a 2880x2160 mp4 x264 25fps to 50fps with Avisynth "smooth" settings.
Encoding is set to specific bitrate 2-pass. AVC High 5.2.
But the rendering is stopping at the beginning sometimes at 1% sometimes at 3 or 4%. and i'm not getting any error message in the log.
It just stop and stay at whatever % it's blocked to.
I mannaged to get it done only once after 5 or 6 trials with a short clip of 45 secondes. and then i tried again with the exact same settings for a 30 minutes clip and it always stops.