This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

[HELP] Any Way to Only Encode A Little Bit, Stop the Encode and Then Check the Result?
#6
Quote:Thank you, so is that recommended?
No, it's not.
It's necessary evil. Hybrid tried to keep color conversions down and only converts from one to another color space if necessary.
So unless you use a filter which only works in RGB (or requires RGB), configure Hybrid output to RGB or feed it with RGB content Hybrid will only use RGB<>YUV conversions for preview.

The color matrix info is usually saved inside the VUI info of a stream so that the decoder knows which color matrix to use to convert YUV content to RGB for playback.
So if your playback color is 'off' and you didn't use RGB<>YUV conversions or explicitly changed the color matrix during filtering, you can simply change the VUI info in the encoder.

Cu Selur
Reply


Messages In This Thread
RE: Any Way to Only Encode A Little Bit, Stop the Encode and Then Check the Result? - by Selur - 13.11.2020, 05:53

Forum Jump:


Users browsing this thread: 1 Guest(s)