This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

MKC Cutter läuft nicht
#6
Quote:Ist das scannen am Anfang wirklich nötig? Das Scannen dauert viel länger als das indexieren mit ffms2. Also wirklich Deutlich länger?
a. key frames müssen bekannt sein
b. je nach Quelle müssen die time codes bekannt sein
-> Ja, der Scan ist nötig.

Quote:Wäre nicht schlecht, wenn das Programm beim Output Namen den Namen vom Input nimmt. Vielleicht mit einem _cut dahinter.
...
Wäre es Sinnvoll das wenn gescannt wurde. Die Daten gespeichert werden. So das wenn man es noch mal reinladen will nicht wieder gescannt wird?
Da es sich nur um eine proof-of-concept Implementation handelt sehe ich hier keinen Handlungsbedarf.

Quote:Auch ein FullHD 18 Gig MKV läuft Butterweich in der Vorschau.
Was vor allem durch das vorherige Scannen der Datei möglich ist.

Quote:Wenn es nun noch SRT und IDX scheiden kann.
Sowohl srt als auch idx Dateien sollten eigentlich mit geschnitten werden. (!pgs/sub nicht!)
Reply


Messages In This Thread
MKC Cutter läuft nicht - by Koto - 25.06.2017, 19:41
RE: MKC Cutter läuft nicht - by Selur - 25.06.2017, 19:55
RE: MKC Cutter läuft nicht - by Koto - 25.06.2017, 22:06
RE: MKC Cutter läuft nicht - by Selur - 26.06.2017, 05:18
RE: MKC Cutter läuft nicht - by Koto - 02.07.2017, 18:04
RE: MKC Cutter läuft nicht - by Selur - 02.07.2017, 18:27
RE: MKC Cutter läuft nicht - by Koto - 02.07.2017, 18:31
RE: MKC Cutter läuft nicht - by Selur - 03.07.2017, 05:19
RE: MKC Cutter läuft nicht - by Koto - 03.07.2017, 17:16
RE: MKC Cutter läuft nicht - by Koto - 04.07.2017, 21:57

Forum Jump:


Users browsing this thread: 1 Guest(s)