Convert to 60fps

[Selur]

Here are possible ways to get it to 60fps.

• Start Hybrid
  
• Set 'Base->Processing->Audio' to 'passthrough all' since we want to keep the audio as it is.
  
• Choose the encoder you want 'Base->Processing->Video' for simplicity I kept it set to 'x264'
  
• Configure the encoder the way you want. (I just changed 'x264->Base->General Settings->Encoding mode' to 'constant rate factor (1-pass)', but depending on your resolution you might need to use a higher value than the default 4.1 under x264->Base->Restriction Settings->AVC Profile/Level.)
  
• Set default folders (Config->Path->Default ...)
  
• Enable 'Config->Internals->Handling->Ignore all input timecodes', so that Hybrid will ignore the time codes and not try to keep them for the output
  
• Enable 'Base->Generate' so that Hybrid will automatically set the output name
  
• Now there are multiple different ways to interpolate the frames.
  
  1. Without Avisynth and Vapoursynth, using FFmpeg
     • Now one can either set:
       • 'Filtering->Speed Change->Speed Settings->Interpolate frame rate' to '60fps', which will interpolate frames to archive the wanted frame rate, or
         
       • 'Filtering->Speed Change->Speed Settings->Scale output frame rate' to '60fps', which will insert duplicate frames to archive the wanted frame rate.
         
  2. Using Avisynth (make sure Filtering->Support is set to 'Avisynth'), don't try to convert 4k+ video with 32bit Avisynth.
     • Here one again has multiple options, all under 'Filtering->Avisynth->Frame->FPS adjust'. Depending on the source some times one or the other interpolation method offers the best results.
       • When using SalFPS3, your need to set 'Filtering->Avisynth->Frame->FPS adjust->SalFps3->Fps' to '60' and depending on your source your will want to tweak some of the other settings.
         
       • When using Interframe, your need to set 'Filtering->Avisynth->Frame->Interframe->Target frame rate' to '60', depending on your system you might also want to enable 'GPU' and depending on your preference you will likely want to set 'Tuning' and 'Override Algo.'
         
       • When using FrameRateConverter, there are tons of settings to play with, can't really recommend anything in general.
         
  3. Using Vapoursynth (make sure Filtering->Support is set to 'Vapoursynth')
     • Again there are multiple choices to archive 60fps, all under 'Filtering->Vapoursynth->Other->Frame Interpolation'
       • 'Interframe/SVP', basically the same as in Avisynth. Remember so set 'FPS' to '60'
         
       • 'MVToolsFPS', remember to set 'TargetFPS' to '60'
         
       • 'FrameRateConverter': same as for Avisynth
         
       • 'Rife' always doubles the frame rate
         
       • 'TorchRife' same as 'RIFE', but with more options (requires special torch addon for Hybrid)
         
• Create a job for the current settings. (Base->Add to queue)
  
• Start the job processing. (Jobs->Queue->Start)
  

Note that each of the methods has it's downsides and it's 'normal' to get artefacts when interpolating frames.

Cu Selur