[HELP] Reducing frame rate 60fps ->30fps
#11
(10.12.2018, 05:52)Selur Wrote: Over here both ways worked fine with the dev version and I'm curious what might be the problem when you use it. Smile

I started to work on it and noticed that this time both Vapoursynth and Avisynth +sRestore + CFR output' worked! :-) 

I don't know why it didn't before. I must have changed some other options as well. 

Thanks again 
Reply
#12
I've just notices that for my video input (60fps from smartphone) even without any frame rate conversion (just x264 re-compression) program can't finish the job and it doesn't save the file. This is for the dev version you send me in PM. This is for CRF off

It works when I set CRF ON
Reply
#13
You are right, seems like I broke some stuff when handling vfr content while rewriting the subjob processing.
Will fix and send you a new dev version once I'm finished. Smile
-> seems like only a small fix was needed, send you a link for testing.

Cu Selur
Reply
#14
(11.12.2018, 06:03)Selur Wrote: You are right, seems like I broke some stuff when handling vfr content while rewriting the subjob processing.
Will fix and send you a new dev version once I'm finished. Smile
-> seems like only a small fix was needed, send you a link for testing.

Cu Selur

Quick summary after testing most recent version with 60fps file

1. Simple re-compression, without frame rate change, works with both CFR on and off
2. When I reduce frame rate to 30fps using Filtering->Speed Change->Scale output frame rate to 30fps:
      - if CFR is off output is as I described in my first post (not good)
      - if CFR is on output is good (30fps)
3. When I reduce frame rate to 30fps using Avisynth with Frame->sRestore
      -if CFR is off output is good (30fps)
      -if CFR is on output is good (30fps) but it doesn't say  "Job **** finished!"
4. When I reduce frame rate to 30fps using Vapoursynnth with Other->sRestore
      -if CFR is off output is as I described in my first post (not good)
      -if CFR is on output is good (30fps)
Reply
#15
I'll look into it some more and later send you a new link via PMSmile

Cu Selur
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)