[HELP] Telecine content
#1
Hello,

Living in PAL land I don't come across a whole lot of telecine content so I was hoping to get some advice on the below source file ripped directly from DVD myself and cut using mkvtoolnix:

https://drive.google.com/open?id=1pzm-A3...2fxmPKTVd0

I've tried a few different variations of TIVTC Vapoursynth and Avisynth but haven't gotten a result where I don't get some jerkiness, especially in panning scenes. The best result i've had so far is using the default TIVTC Avisynth settings.

Any recommendations?

Thanks
Reply
#2
Source is flagged as 29.97 interlaced not telecine (3:2 pulldown) so applying IVTC is probably the wrong approach.
Looking through the dvd with running a bobber and also without deintrlacing at all one can see that some parts of the content are normal interlaced and some parts are progressive. (+ some glitched due to bad authoring)
-> Personally I would apply QTGMC and stick with that.

Cu Selur
Reply
#3
Thumbs Up 
(11.02.2019, 19:26)Selur Wrote: Source is flagged as 29.97 interlaced not telecine (3:2 pulldown) so applying IVTC is probably the wrong approach.
Looking through the dvd with running a bobber and also without deintrlacing at all one can see that some parts of the content are normal interlaced and some parts are progressive. (+ some glitched due to bad authoring)
-> Personally I would apply QTGMC and stick with that.

Cu Selur

Thanks for looking into it, I was looking at the telecine option as the analyze option suggested to use TIVTC. 

I'll run with QTGMC instead
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)