Esxi running macos For selur

[Selur]

Normally I would:

• load source
  
• start Vapoursynth Preview (often interleaved)
  
• open Vapoursynth Script view
  
• if source is flagged as interlaced/telecine and I suspect it might not check how it looks when I assue it's progressive or when I bob it, then adjust the deinterlacing
  
• then I would look at the source decide what filters are needed and depending on the results when using filter queue I might change the filter order (usually not) and/or switch to filter queue to write some manual code.
  

Since I don't move filter wildy arround I usually know what I did and what the order is.
Also I can simply look at the script view in case I'm unsure about what I'm doing.
Like I wrote: "I will think about it,.."

Cu Selur