10.12.2022, 02:13
Hi Selur,
I set the default output path.
But I do not see a place where I can set the name of the output file....
I enabled the debug output. (located at the top right corner)
But not once a debug file was created.
I did not correctly describe the error that happened with the 200Seconds file.
What went wrong is that the encoding was extremely fast, because only a few frames at the beginning of the movie were encoded.
All other frames were not encoded. I think you must also have seen this when you tried encoding the 200S file.
Anyway, your first suggestion worked: Use DGDecNV when available.
With that option enabled, the whole movie will be encoded.
Thank you again!
I set the default output path.
But I do not see a place where I can set the name of the output file....
I enabled the debug output. (located at the top right corner)
But not once a debug file was created.
I did not correctly describe the error that happened with the 200Seconds file.
What went wrong is that the encoding was extremely fast, because only a few frames at the beginning of the movie were encoded.
All other frames were not encoded. I think you must also have seen this when you tried encoding the 200S file.
Anyway, your first suggestion worked: Use DGDecNV when available.
With that option enabled, the whole movie will be encoded.
Thank you again!