It would be helpful if jobs in the job queue could be sent back into the job setup interface so that past jobs could be edited easily without having to go through the same steps to set up a new job. Could this be added to Hybrid because I don't think there is any way to edit a job in Hybrid once it has been added to the job queue.
Imagine adding lots of jobs to the job queue and later the encoder crashes because of an error in one of the jobs. As it stands at the moment there is no way to recall a job to correct any problems. It would make it far faster and easier if a job in the job queue could be sent back into the job setup interface so that corrections could quickly be made. As it is ATM the whole job needs to be setup from scratch.
Is this possible to do? Thoughts and opinions on this are welcome.
Imagine adding lots of jobs to the job queue and later the encoder crashes because of an error in one of the jobs. As it stands at the moment there is no way to recall a job to correct any problems. It would make it far faster and easier if a job in the job queue could be sent back into the job setup interface so that corrections could quickly be made. As it is ATM the whole job needs to be setup from scratch.
Is this possible to do? Thoughts and opinions on this are welcome.
