This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Dolby Vision to SDR converting problem
#10
Can you tell me, studying vs-placebo github link, I found several commands that are not presented in Hybrid's Tonemap (Placebo) settings section, these are:

metadata: Data source to use when tone-mapping. Setting this to a specific value allows overriding the default metadata preference logic. Defaults to 0 (automatic selection).
0 Automatic selection
1 None (disabled)
2 HDR10 (static)
3 HDR10+ (MaxRGB)
4 Luminance (CIE Y)
visualize_lut: Display a (PQ-PQ) graph of the active tone-mapping LUT. See mpv docs.
show_clipping: Highlight hard-clipped pixels during tone-mapping.
contrast_recovery: HDR contrast recovery strength. If set to a value above 0.0, the source image will be divided into high-frequency and low-frequency components, and a portion of the high-frequency image is added back onto the tone-mapped output. May cause excessive ringing artifacts for some HDR sources, but can improve the subjective sharpness and detail left over in the image after tone-mapping. Defaults to 0.0.

Can the default settings of these commands (one of them) give the autobrightness effect that we were talking about?
Reply


Messages In This Thread
RE: Dolby Vision to SDR converting problem - by shurikello - 05.06.2024, 23:41

Forum Jump:


Users browsing this thread: 3 Guest(s)