This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Selur's Little Message Board › Hybrid - Support › Problems & Questions v
How to change output frame rate?

Threaded Mode
How to change output frame rate?
williamduffy Offline
Junior Member
**
Posts: 38
Threads: 17
Joined: Jul 2021
#1
22.09.2024, 03:54
Since doing a complete reinstall of Hybrid and using QTGMC with Bob enabled I was hoping to double the frame rate but Hybrid is still outputting to the original 25fps. I have forgot how to change that setting?
Find
Reply
Selur Online
the author
*******
Posts: 10.565
Threads: 57
Joined: May 2017
#2
22.09.2024, 07:01
Hybrid will automatically adjust the frame rate when deinterlacing with bob.
My guess is Hybrid does not deinterlace, since the source is not detected as interlaced.
If your source is not properly flagged and misidentified, overwrite the scan type to the correct value.

Cu Selur
----
Dev versions are in the 'experimental'-folder of my GoogleDrive, which is linked on the download page.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)