Help with interlaced or telecined frames

[Selur]

But QTGMC input type 2 & 3 are meant for deinterlacing. isn't it?

0 for interlaced input. Settings 1,2 & 3 accept progressive input for deshimmer or repair. Frame rate of progressive source is not doubled. Mode 1 is for general progressive material. Modes 2 & 3 are designed for badly deinterlaced material.

SRestore not working in Vapoursynth. Encoding stops in the middle all the time. So i can't able to remove blending or ghosting.

that is strange, works fine here. Jumping in a source in the preview will not work, but encoding or progressively going through the source without jumping works fine here.
Check your RAM usage during encoding, iirc. it might help to lower the thread count in Vapoursynth if sRestore&co are running out of RAM.

Cu Selur