23.08.2017, 21:29
Ok I shall keep digging, you've got me on the right path for sure, it's the rate factor that scares me now!
I'm going to test the settings below (wit a few ups and downs on the rate factors) and will report back if all was successful!
I don't normally get asked for such strict restrictions on bit rate either, but apparently for HDR constant is better because it preserves tiny details that could easily be compressed. And this is an UHD, HDR 50fps file, they couldn't be using more bitrate nonsense as it is!
Anyway thanks for providing one of the only GUIs out there than can really encode a HDR signal
Settings:
x265 --input - --output-depth 10 --y4m --profile main10 --limit-modes --no-open-gop --bitrate 40000 --crf-min 10.00 --crf-max 20.00 --strict-cbr --cbqpoffs -2 --crqpoffs -2 --qpfile GENERATED_QP_FILE --psy-rd 2.50 --rdoq-level 2 --psy-rdoq 10.00 --aq-mode 0 --deblock=-1:-1 --limit-sao --colorprim bt2020 --transfer smpte-st-2084 --colormatrix bt2020nc --hdr --output OUTPUTFILE
I'm going to test the settings below (wit a few ups and downs on the rate factors) and will report back if all was successful!
I don't normally get asked for such strict restrictions on bit rate either, but apparently for HDR constant is better because it preserves tiny details that could easily be compressed. And this is an UHD, HDR 50fps file, they couldn't be using more bitrate nonsense as it is!
Anyway thanks for providing one of the only GUIs out there than can really encode a HDR signal
Settings:
x265 --input - --output-depth 10 --y4m --profile main10 --limit-modes --no-open-gop --bitrate 40000 --crf-min 10.00 --crf-max 20.00 --strict-cbr --cbqpoffs -2 --crqpoffs -2 --qpfile GENERATED_QP_FILE --psy-rd 2.50 --rdoq-level 2 --psy-rdoq 10.00 --aq-mode 0 --deblock=-1:-1 --limit-sao --colorprim bt2020 --transfer smpte-st-2084 --colormatrix bt2020nc --hdr --output OUTPUTFILE