Selur's Little Message Board

Hi,

I've installed the latest version, finally moving from MeGUI to Hybrid.

Noticed that I can't use small steps for qcomp and aq values. It's either 0,6 or 0,7, I can't put 0,65. Editing manually the xml file and loading doesn't do anything - I manually written 0,65 qcomp in xml file, loaded it to hybrid, did the encoding and the result shows 0,7 values.

Any chance to use small steps of 0,01 ???

I assume you are using x264, if that's the case I could modify Hybrid to allow 0.01 steps easily,..
(I usually never needed it and nobody ever asked for it. )
As a workaround you could add a custom command line addition.

Cu Selur

(16.01.2021, 21:41)Selur Wrote: [ -> ]I assume you are using x264, if that's the case I could modify Hybrid to allow 0.01 steps easily,..
(I usually never needed it and nobody ever asked for it. )
As a workaround you could add a custom command line addition.

Cu Selur

Yes, sorry, forgot to mention it's about x264.

Would be nice. I got used to middle values like 0,65.

Thank you!

Send you a link to a dev version via pm which allows to use 0.01 steps for qcomp and aq-strength.

Cu Selur

(16.01.2021, 22:14)Selur Wrote: [ -> ]Send you a link to a dev version via pm which allows to use 0.01 steps for qcomp and aq-strength.

Cu Selur

It works! Thank you!!

Good evening Mr. Selur, I am also interested in being able to set the parameters of 0.01, could you also send me the new version?

Thanks and regards 

Send you a link,..

Cu Selur

(17.01.2021, 08:13)Selur Wrote: [ -> ]Send you a link,..

Cu Selur

Thanks Selur