Selur's Little Message Board

Hi guys! I'm hitting my head for hours beacause I have a problem with Hybrid.  I want a convert a .mp4 25fps video in 60fps because I want it more smooth...I set the usual configuration and I start. For the first time I waited about 15 minutes to have my video ready, but when it finished...I haven't had the video and I got an error. I tried to do something but nothing, and now when I try more times, the 1st pass goes well and then it stops and says: 2nd pass has more frames than 1st pass and finishes. Finally the video is in 60fps, but the image stops after 4-5 seconds about.  Oh and I haven't said a thing yet. As soon as the audio encoding finishes and the 1st pass starts, my computer showes me this error: "Close programs to prevent information loss Your computer is low on memory. Save your file and close this programs: ffmpeg Windows will only close enough programs to restore needed memory" because I have little space in my ssd. What I have to do? Do I have to free some space? Do I have to change my Hybrid configuration or the video is bad? From some sources I read maybe may be an audio codec problem...Please help meeee

1st clear the content of the temp folder you use in Hybrid
2nd read the sticky properly and post a debug output of what you are doing.
That way I should have some useful data to see what is causing the problem.

Cu Selur

(13.12.2017, 17:58)Selur Wrote: [ -> ]1st clear the content of the temp folder you use in Hybrid
2nd read the sticky properly and post a debug output of what you are doing.
That way I should have some useful data to see what is causing the problem.

Cu Selur

Thank you Selur! Now I will try to do what you told. I update you for something

---

(13.12.2017, 17:58)Selur Wrote: [ -> ]1st clear the content of the temp folder you use in Hybrid
2nd read the sticky properly and post a debug output of what you are doing.
That way I should have some useful data to see what is causing the problem.

Cu Selur

Sorry Selur, where is temp folder?

see: 'Config->Path->Default temp path'

(13.12.2017, 18:49)Selur Wrote: [ -> ]see: 'Config->Path->Default temp path'

Where can I find the Config button? Oh sorry I found it

---

(13.12.2017, 17:58)Selur Wrote: [ -> ]1st clear the content of the temp folder you use in Hybrid
2nd read the sticky properly and post a debug output of what you are doing.
That way I should have some useful data to see what is causing the problem.

Cu Selur

I'v e cleaned the temp folder and I have enabled the debug output, but the program says this: currentdefaulttemppath is empty! set it under config=>path

*gig* you misunderstood, I didn't want you to clear the setting in Hybrid, I wanted to you clear the folder on your hdd.