Selur's Little Message Board

I have multiple files. I can load them to Hybrid, I can adjust different filters to each of the clips.
And now I need to convert them into one resulting file in which those clips would go one by one, like different scenes of the movie. Is it possible to do it in hybrid? The only thing I see is hybrid converts each file into different file.
I know, i can convert those files with identical settings and then join them with "Stream copy" with other programs, but i want to avoid that excessive step.

Another little question. If i have multiple input files and I do enabled Cut Support - can I set Cut parameters for each clip? Now those parameters are the same for all the clips even if I try to switch to different clip.

I use version 2017.12.23.1 32-bit

Quote: Is it possible to do it in hybrid?

No. Hybrid doesn't allow to concatenate clips and this something that will probably never be added.

Quote:If i have multiple input files and I do enabled Cut Support - can I set Cut parameters for each clip?

Not unless you add the clips one by one, configure them one by one and create a job for them one by one.

Cu Selur

(30.01.2018, 21:41)Selur Wrote: [ -> ]

Quote: Is it possible to do it in hybrid?

No. Hybrid doesn't allow to concatenate clips and this something that will probably never be added.

Quote:If i have multiple input files and I do enabled Cut Support - can I set Cut parameters for each clip?

Not unless you add the clips one by one, configure them one by one and create a job for them one by one.

Cu Selur

Thanks for quick reply! Anyway I like your program.