Selur's Little Message Board

Hi everyone .
Is there a way to trim in Hybrid?
I should cut a video, keeping only the one from frame x to frame y, is this possible?
I can't find the option that allows this.
I use vapoursynth
Thanks in advance

Yes, there is such an option.
Won't share details since writing everything in uppercase is the same as screaming and I don't help folks that scream at me without reason.

Cu Selur

Sorry, I forgot, it wasn't my intention to offend you and/or anyone else
I don't frequent forums much,
sorry again . 

Enable "Config->Internals->Cut Support *experimental*->Frame selection" (make sure to read the tool-tips).
When the option is enabled, you can set a start and end frame in the Base-tab.

Cu Selur

Thank you very much and sorry again for writing in uppercase