Selur's Little Message Board

I have been using Hybrid for a couple of years now, often for the same purpose. Once in a while, on a machine, I will have the same issue. A job will complete after a couple of hours, and then immediately begin again.

I am taking a file from AVI to 264. Upscaling to 1080. De-Interlace. After getting to 100% and finishing the job, the process begins again.

If I restart the computer or try the same on other machines it will work. Every so often, including today, I have this repeat issue.

What could it be? What can I provide? Does this make sense to anyone?

I love the software. This is the only issue I have had.

No clue, that never happened to me so far.
If you find a way to reproduce this, I'll happily look into it.

Cu Selur

Hi. It is currently happening. So let me know what I can pass along.
After completing the job, it started again. At about a minute into the new round I have paused it in the jobs tab.

Is there anything I can look into or pass along? It is currently paused…

It appears in the Base Tab info that after almost 4 hours the video finished. Then, immediately started again.

Create a debug output of when it happens again and share that with me.
It hopefully should help to find where this comes from.
Do you have anything enabled under Jobs->Misc ?
Have to go to bed now, but if you share a debug output of the problem happening, I might be able to see something in it tomorrow.

Cu Selur

Hi. Thank you. - Nothing under Jobs, Misc.

I will create a Debug File and Report (under Internals) for the next try. If there is anything else to add to create data I will do that as well.

Report is useless for me just the debug output is fine.
Thanks.

Cu Selur