Selur's Little Message Board

I'm trying to stretch out a 25fps video to 24fps. in Filtering -> Speed Change I use the "speed change" option to set desired framerate to 24, and on the audio tab I select to re-encode audio as flac, and "speed change" from 25 -> 24.

When the job runs, I get about 3 warning dialogs saying script framerate (24) differs from calculated framerate (10). I don't know how it's calculating 10, the source seems to be definitively 25fps as far as I can tell. The job seems to get as far as encoding the flac audio, but then dies.

Probably some typo in the parsing code, will look at it at the end of the week when I am back home.
You can try whether I fixed this in a dev build already,...

Cu Selur

The combobox didn't update the value in the calculation.
=> uploaded a new dev which adds the required trigger

Cu Selur

(16.12.2025, 17:45)Selur Wrote: [ -> ]The combobox didn't update the value in the calculation.
=> uploaded a new dev which adds the required trigger

Ha ha, I just tried the 4426 build a couple of minutes ago (same problem), now I don't see a dev build at all but I guess google is still processing the new upload.  I'll try again in a little while.

Many thanks!

Posted after uploading Hybrid_dev_2025.12.16-16236, so yes it might take a bit for google to sync their servers,..

(16.12.2025, 18:26)Selur Wrote: [ -> ]Posted after uploading Hybrid_dev_2025.12.16-16236, so yes it might take a bit for google to sync their servers,..

Thanks, yes, and I can confirm it works well now to change the video/audio speed.