Hybrid dies silently - Printable Version +- Selur's Little Message Board (https://forum.selur.net) +-- Forum: Hybrid - Support (https://forum.selur.net/forum-1.html) +--- Forum: Problems & Questions (https://forum.selur.net/forum-3.html) +--- Thread: Hybrid dies silently (/thread-1680.html)

Hybrid dies silently - incans - 16.01.2021 Hardware: Core i7-4770K, 16GB RAM OS: Windows 7 Pro 64bit Hybrid: 2020.12.13.1(dev patch) Strange one this. I was processing a DVD rip of the film "Near Dark" and doing other things (web browsing) on the machine when I realised Hybrid had stopped processing. The Hybrid UI was still running, but the job had stopped part way through pass 2 of the video transcode, CPU had dropped to idle. It looked as of the transcoder had died silently, leaving the front end waiting for ever. Now, after a reboot I am trying to run Hybrid again but each time I start it it just quits immediately. If I run it from a Cmd window there is no debug info or crash dump output so it's hard to tell what is going on. Of course as I can't get Hybrid to run, I can't get as far as enabling the debug log. This is similar to the problem I had before with the dev build and (known) issue with one of the DLLs, but to be clear this time around I have not changed anything, and i can't see any obvious damage in the Hybrid install directory. Could the failed transcode have left a tmp file or lock file around somewhere that is preventing Hybrid from restarting? RE: Hybrid dies silently - Selur - 16.01.2021 try creating a misc.ini next to your Hybrid.exe and write: [General] ignore=QSVEnc If that doesn't help, zip your settings folder and share it with me. Cu Selur RE: Hybrid dies silently - Selur - 16.01.2021 Since I can't reproduce this here, I'll send you a link to my current dev version. Cu Selur RE: Hybrid dies silently - incans - 07.02.2021 Sorry for the deleyed reply, busy with work. The misc.ini trick worked, which is good (I assume...) I assume that means QSVEnc is the problem. Do I need to do a re-install of QSVEnc alone (if that's possible?) or the whole of Hybrid, to get it running again? As i'm currently running a dev version I would be scratching my head to remember the sequence to get back to the same installation setup. I'll check for a new release version.