01.04.2021, 17:35
I did not set sync lookahead value manually, it just came from some settings combination and kept staying.
I will not pay attention to it as it does not affect compression process, compatibility.
One more thing has changed since a fresh install, the Macroblock Settings.
I did not set them before either, they came by playing with some settings.
I am using "Slower" preset.
Before in the Command Line was:
--partitions all --8x8dct
And the Macroblock Settings:
x264>Motion Estimation>Macroblock Settings> "P4x4" and "Allow P4x4 at all levels" boxes were checked.
After reinstalling Hybrid, starting with Hardware restriction settings for BluRay and getting AVCHD 2.0 compliant settings, those two options are unchecked, in the Command Line:
--partitions i4x4,i8x8,p8x8,b8x8 --8x8dct
Is it OK, or should I check those options?
I will not pay attention to it as it does not affect compression process, compatibility.
One more thing has changed since a fresh install, the Macroblock Settings.
I did not set them before either, they came by playing with some settings.
I am using "Slower" preset.
Before in the Command Line was:
--partitions all --8x8dct
And the Macroblock Settings:
x264>Motion Estimation>Macroblock Settings> "P4x4" and "Allow P4x4 at all levels" boxes were checked.
After reinstalling Hybrid, starting with Hardware restriction settings for BluRay and getting AVCHD 2.0 compliant settings, those two options are unchecked, in the Command Line:
--partitions i4x4,i8x8,p8x8,b8x8 --8x8dct
Is it OK, or should I check those options?