This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Selur's Little Message Board › Hybrid - Support › Problems & Questions v
Trying to bob deinterlace using DGDecNV, getting mkv with only audio

Linear Mode
Trying to bob deinterlace using DGDecNV, getting mkv with only audio
antoniu200
Unregistered
 
#5
18.08.2021, 18:50
Hybrid does not create the debug file at the specified output directory until I save the debug config and then restart it. It does seem to output in the directory where I choose my input file from. Attached below.

After I restart and follow your instructions, this is what I get.
Reply


Messages In This Thread
RE: Trying to bob deinterlace using DGDecNV, getting mkv with only audio - by antoniu200 - 18.08.2021, 18:50

Forum Jump:


Users browsing this thread: 4 Guest(s)