Trying to deinterlace with Bob NVEnc; job crashes

[Selur]

I tested NVEnc and its Bob deinterlacing in FFMpeg using this "

Thats like saying: my car doesn't work then I took the bus and it worked, so why does my car not work.
Yeah, both might have a motor, wheels and other things in common, but they are totally different.

Your debug output ends with:

2021.08.18 - 21:08:48_Windows 10 Version 1607 (64bit)_2021.07.18.1 - level 9: Output is matroska compatible,.. -> changing current container to mkv,..
2021.08.18 - 21:08:48_Windows 10 Version 1607 (64bit)_2021.07.18.1 - level 9: outputDir set to(2): C:\Users\Alexa\Desktop

You changed the output thus the location of the debug output changes.
I have no clue what is so difficult in first setting the output to a location and then enable the debug output, that you can't get it right any time you post a debug output.

What the sticky says:

[*]Debug output would be helpful:

1. start Hybrid
   
2. set an default output path: Config->Paths->Default output path
   (This is where the debug output will be created unless you specify an output file inside another path.
   If an old HybridOutput.txt already exists in that folder delete it.)
   
3. enable Debug output: Config->Internals->Create debug file (unless told to, do not change the debug level)
   
4. do everything you did to create you problem
   
5. compress (zip/7z/rar/..) the HybridDebugOutput.txt before you post it
   

Without a debug output I have no clue what you are doing.
-> I have no clue how I should help you.

May be using Handbranke, StaxRip, MeGui, Vidcoder or other alternative tools might be the better choice for you.



Cu Selur