TS mux → crash .. again !?

[ToiletDuck]

No, it describes what the tsMuxeR command line tool should multiplex with what settings.

ah i see, and i asume each setting will be different depending what the content of the media files , isnt it?
And you suspect that tsmuxer reads an wrong or corrupted meta file ?

No, it describes what the tsMuxeR command line tool should multiplex with what settings.
I suspect more and more that it's not the muxing, but the extraction.
Try the following two things:
1. disable "Config->Internals->Extraction->Prefer ffmpeg for extraction from transport stream" and see whether that changes anything. Hybrid should then use tsMuxeR for the extraction. (if this fixes it, its the extraction with ffmpeg)
2. try if you enable "Config->Containers->General->Keep intermediat files", this way Hybrid will not delete the extracted stream after muxing. Then see whether muxing those streams with the tsMuxeR GUI produces another output than Hybrid. (should be the same, assuming they use the same .meta file, if it's the same and flawed it's not the muxing, but the extraction) You could also set the output to .raw as extension. (If you don't want the muxed file, you can also enable 'No multiplexing and splitting'. (Hybrid will then ignore the muxing step.)

 Iam one step ahead of ya.. I have thought of the extraction process aswell.  

And i have tried out point 2... as you described. and have used the a/v tracks hybrid / tsmuxer have demuxed / extracted and used these files to recompile the whole file through tsmuxer gui myself by adding the files 1 by 1 you know..

And that's why i wos refering to the manual muxing always, manually seems to have no issues at all 

Thanks for suggesting point 1... 

But this isn't it either, since for one i 've succesfully muxed it using the very same tracks hybrid or rather tsmuxer & ffmpeg has extracted.
And sure enough the same phenomenon keeps happening !  No audio in PDVD, the "non supported format" message from the bdplayer !
 
So, again. just to be sure its not an "extraction" issue, atleast all the trial and errors points in that direction... 
I have used the very same a/v tracks that FFmpeg this time did extracted through hybrid and remuxed it myself manually in tsmuxerguy..

You've guessed it → flawless playback 

You see, at one hand it's seems not to be an demux issue, and on the other not an mux issue aslong it's done manually .. the mux part!

Hence , why i asked to add the option for an custom bitrate for eac3.  
Since , pretty much everything is done by ffmpeg and ffmpeg uses custom bitrate last time i've checked..  



A real fine mess i got myself into... 


Fyi, the ffmpeg setting is not in Config→Internals→etc ... but under Config→Input→extraction.. atleast in the release you pm'd me ..

Am i right, and do you use FFmpeg not only for audio encoding but for extraction / remuxing aswell?  
Are we talking about the same tooL ?





Thanks for the efforts 

cheers,
TD