03.02.2021, 18:38
Hybrid has an experimental cut support which allows to just encode a (one) specific part.
You can enable it through "Config->Internals->Cut Support" (make sure to read the tool-tips), which then enabled additional controls in the Base-tab.
Cu Selur
You can enable it through "Config->Internals->Cut Support" (make sure to read the tool-tips), which then enabled additional controls in the Base-tab.
Cu Selur
----
Dev versions are in the 'experimental'-folder of my GoogleDrive, which is linked on the download page.
Dev versions are in the 'experimental'-folder of my GoogleDrive, which is linked on the download page.