Selur's Little Message Board

What is your output format?

Input - ProRes 422HQ SD PAL 25fps / Output ProRes 422HQ 1080i 25fps

Quote:Output ProRes 422HQ 1080i 25fps

Normally enabling "ProRes->Interlacing" should do the trick.
Might be a bug if Hybrid still deinterlaces.
-> looking into it.

Cu Selur

I already tried that setting, may be a bug?

---

Step-by-step:

Add file (ProRes 422HQ SD PAL Interlaced)
-> ProRes 422HQ
-> Deinterlacing - Off
Crop/Resize-> Convert to square pixels
Crop/Resize -> Height 1080
Filtering -> DeGrain -> MLDegrain
Filtering -> Sharpen -> CAS
Filtering -> Frame -> Resize -> NNEDI3

Quote:I already tried that setting, may be a bug?

Yes, it's a bug.
Fixed it locally, will send you a new dev version for testing.

Folling your step-by-step, I did the following:

1. started Hybrid.
   
2. opened the file you send (Base->File open).
   
3. set 'Base->Processing->Video' to 'ProRes'.
   
4. set 'ProRes->Profile' to 'ProRes 422HQ'.
   
5. enabled 'ProRes->Interlacing'.
   
6. (I did not touch the Deinterlacing, since it now shouldn't be applied.)
   
7. I enabled 'Crop/Resize->Base->Pixel Aspect Ration (PAR)->Convert output to PAR'.
   
8. I set 'Crop/Resize->Base->Picture Resize->Auto adjust' to 'width'.
   
9. I set 'Crop/Resize->Base->Picture Resize->Target resolution' to '1080' (no Output resolution shows (1476x1080).
   
10. I enabled 'Filtering->Vapoursynth->DeGrain->MLDegrain'.
    
11. I enabled 'Filtering->Vapoursynth->Sharpen->CAS'.
    
12. I enabled 'Filtering->Vapoursynth->Frame->Resize->Resizer'.
    
13. I set 'Filtering->Vapoursynth->Frame->Resize->Resizer' to 'NNEDI3'
    

I pressed the 'Vapoursynth Preview' button and Hybrid froze. (this is a bug, not sure where atm.)
-> looking into it.

Just to make sure: This is what you did, right?

Cu Selur

Yes, that looks OK.

Okay, I know what causes the problem.
Since NNEDI3 does not work on interlaced content, Hybrid needs to either deinterlace and then reinterlace or split the interlaced frames into their field and apply the filter on both fields. (This can be controlled through 'Filtering->Vapoursynth->Script->Filter interlace handling'.)
And there is the bug, in which Hybrid does not properly set all the variables and thus when splitting into fields the cropHeight&Width are 0 which when causes an infinite loop during the pow-calcculation for NNEDI3.
-> looking into it.

Cu Selur

What could I use instead of NNEDI3?

Issue isn't NNEDI3, which actually does support interlaced content, but the combination of filtering with filters that do support interlacing and those that do not. (like CAS)

Resizers that will fail, are:

• NNEDI3
  
• Anime4k
  
• BasicVSR
  
• RealSR
  
• SRMD
  

which are some of the best.
Setting 'Filtering->Vapoursynth->Script->Filter interlace handling' to something else than 'separate fields' should work until I figure out how to fix it for 'separate fields' too.

Cu Selur