This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

[HELP] Hybrid stuck processing
#1
I'm using Avisynth for sRestore as it's broken in Vapoursynth.

Hybrid has stopped processing at 0.05%. Any suggestions?

The debug file is too big to attach here. Link here
Reply
#2
Can't access the debug output.
Normally, compressing and attaching the debug output should work fine.

Cu Selur

Ps.: As a side note: I would recommend switching to 64bit Avisynth,...
Reply
#3
Compressed DeBug added. Thanks Smile
Reply
#4
Sadly, the debug output doesn't show any error.
FFmpeg seems to process the first 58 frames and then the debug output stops.

Wild guesses:
32bit Avisynth runs out of RAM => try whether switching to 64bit and recreating the job helps.
Might be an issue with the source and the used source filter => try whether the preview works fine for the first ~100 frames.

Cu Selur
Reply
#5
How do I switch to 64bit? I've not used Avisyth option until the past few days.

I have run the same file before with no problem, strange.

I am going from QTGMC 25i bob to 23.976 progressive. Will the problem in sRestore/Vapoursynth affect this if I go back to processing in Vapoursynth?
Reply
#6
Quote:How do I switch to 64bit?
set "Config->Internals->Avisynth->Avisynth type" to "64bit"

Quote:I am going from QTGMC 25i bob to 23.976 progressive. Will the problem in sRestore/Vapoursynth affect this if I go back to processing in Vapoursynth?
yes, read https://forum.doom9.org/showthread.php?t=184852

Cu Selur
Reply
#7
I'm not sure why, but I'mstillĀ  seeing interlacing in the filtered preview. Any ideas?
Reply
#8
Quote:I'm not sure why, but I'mstill seeing interlacing in the filtered preview. Any ideas?
Frame->Misc->VInverse, Frame->Misc->VInverse2, Denoise->QTGMC (input type=2 or 3) can probably help.
Other than that: no clue

Cu Selur
Reply
#9
Another error:

Avisynth preview error: -> SeparateFields: YUV420 height must be multiple of 4 (C:\Program Files\Hybrid\64bit\Avisynth\avisynthPlugins\QTGMC.avsi, line 843) (M:\TEMP\tempPreviewAvisynthFile16_26_12_568.avs, line 48)
Reply
#10
Seems like a user error, adjust your processing accordingly.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)