Posts: 53
Threads: 6
Joined: Dec 2019
I tried to extract the subtitle from a m2ts file but I receive an error message even if tsmuxer can do it without any problem, in fact I did it manually.
I don't know if it's a bug.
Posts: 53
Threads: 6
Joined: Dec 2019
I wanted to encode a second Blu-ray but when I click to create the job an error message pop up about invalid GUI state.
Posts: 10.560
Threads: 57
Joined: May 2017
17.10.2023, 05:11
(This post was last modified: 17.10.2023, 05:15 by Selur.)
Those are rare, haven't seen one for ages.
From the looks of it, this happens when Hybrid tries to extract subtitle from "N:\BDMV\STREAM\00004.m2ts" and decides it can't.
Not sure why it's not using tsMuxeR or ffmpeg => will look at it after work and report back.
Looks a bit like you are using the Subtitle->Tab to load an .mpls file and then try to extract the subtitles through there, instead of using the controls on the Base-tab.
Cu Selur
----
Dev versions are in the 'experimental'-folder of my GoogleDrive, which is linked on the download page.